单面铆接铆钉，受到使用特殊工具铆钉机（手动，电动，气动）铆。铆钉，铆钉芯由专用铆钉枪，所以铆铆接体积膨胀，发挥作用。这种铆钉，特别适用于不便普通铆钉铆）（从两边是铆接场合，它广泛应用于建筑，汽车，飞机，船舶，机械，电器，家具和其他产品。头扁开放型盲铆钉应用最广泛的适用性能平稳的铆接场合，自攻螺丝，封闭型铆钉对需求的高负荷和铆接场合具有一定的密封性能。

 

一般使用的铆钉

 

孔大小的铆钉孔+ 0.1分钟最大+ 0.2工件厚度一般为45% - 65%的铆钉长度，最好不大于60%。短长度的工作太多麻烦。建议，通常50% - 60%为准。例如：如果2个或以上的总厚度的工件毫米那么铆钉应该能够选择的长度应该是9.23 ---一十三点三毫米。这是其中最好的12毫米长，更合适。气动铆钉枪--------------直接向气磅小螺丝钻，如载以下是除了6.4（6）直径。可以拉。6.4（6），有些枪可以拉然而，更昂贵的外国！

 

 

 

   One-sided riveting rivets, subject to the use of special tools - riveters (manual, electric, pneumatic) riveting. Riveted, the rivet core driven by special riveting gun, so riveting volume expansion, play riveted role. Such rivets are especially suitable for the inconvenience ordinary rivet riveting) (from both sides to be riveting occasions, it is widely used in construction, automotive , on ships, aircraft, machinery, appliances, furniture and other products. Head which oblate to open type blind rivets application most widely applicable to the performance of smooth riveting occasions, self tapping screws, closed rivets for on demand with higher loads and riveting occasions with certain sealing performance.

 

 

    Hole size of the rivet holes +0.1 min. Max +0.2 workpiece thickness is generally 45% of the rivet length - 65%, preferably not higher than 60%. Too short length of the work is too much trouble. Recommendations usually 50% - 60% shall prevail. For example: If two or more of the total thickness of the workpiece is 6mm then the rivet should be able to choose the length should be 9.23 --- 13.3mm. this is the case among the best 12mm long, is more appropriate. pneumatic blind rivets gun -------------- directly to the gas pounds on small drilling screws, such as 14kg following is in addition to 6.4 (6) diameter. else can pull .6.4 (6), some guns can pull However, expensive foreign more!